Filter
Top Products
Chapter 2. TV Connections 27
DVD Player with Component Video
Component video cables and analog audio cables are
required. These are not included with the TV.
1. Connect the component video cables from
COM-
PONENT OUT
(or YPbPr OUT) on the back of the
DVD player to the
COMPONENT
INPUT
jacks on
the TV back panel, matching the red, green, and blue
colored connections.
2. Connect left (white) and right (red) stereo audio
cables from
AUDIO OUT
on the back of the DVD
player to
COMPONENT INPUT/AUDIO L
and
R
on the TV back panel.
Figure 12. Connecting a DVD player with component video
IMPORTANT
See Appendix B for component video signal
compatibility information.
For digital audio connections to your
A/V receiver, see your DVD player and A/V
receiver Owner’s Guides.
A/V Receiver (Stereo System)
Most audio/video receiver setups require either a digital
audio cable or analog stereo audio cables.
The TV makes all audio available in digital and analog
formats. Analog audio coming into the TV is available in
digital format on the
DIGITAL AUDIO OUTPUT
jack.
Incoming digital audio is available in analog format on the
AUDIO OUTPUT L/R
jacks. Usually, only one of the
following connections is required:
• To connect an analog A/V receiver
Connect left (white) and right (red) audio cables from
AUDIO OUTPUT L/R
on the TV back panel to the
TV AUDIO INPUT
on the A/V receiver.
• To connect a digital A/V receiver with Dolby
Digital surround sound and PCM audio support
Connect one end of the digital audio cable to
DIGITAL AUDIO OUTPUT
on the back of the TV.
Connect the other end to the
COAXIAL DIGITAL
INPUT
on the back of the A/V receiver.
Figure 13. Connecting audio from the TV to an A/V
receiver
Note:
On rare occasions, an HDMI signal may be
copy-restricted and cannot be output from the TV
as a digital signal. To hear these copy-protected
signals through the A/V receiver, use connections
for analog A/V receivers.
Check the A/V receiver’s Owner’s Guide for
information concerning use of the digital input
and switching between digital sound and analog
stereo sound from the TV.
The digital audio jack supports digital stereo, but
not muli-channel surround sound.