Filter
Top Products
8
Notice for this monitor
Notice for this monitor
• This product is intended to be usedin displaying and viewing digitalimages for diagnosis
of X-ray orMRI, etc. by trained medicalpractitioners. It does not supportthe display of
mammography imagesfor diagnosis.
• This product has been adjusted specifically for use in the region to which it was originally
shipped. If the product is used outside the region, it may not operate as specified in the
specifications.
• This product may not be covered by warranty for uses other than those described in this
manual.
• The specifications noted in this manual are only applicable when the following are used:
- Power cords provided with the product
- Signal cables specified by us
• Only use optional products manufactured or specified by us with this product.
• As it takes about 30 minutes for the performance of electrical parts to stabilize, adjust the
monitor 30 minutes or more after the monitor power has been turned on.
• Monitors should be set to a lower brightness to reduce changes in luminosity caused by long-
term use and maintain a stable display.
• When the screen image is changed after displaying the same image for extended periods of
time, an afterimage may appear. Use the screen saver or timer to avoid displaying the same
image for extended periods of time.
• Periodic cleaning is recommended to keep the monitor looking new and to prolong its
operation lifetime (Refer to “Cleaning” (page 9).)
• The screen may have defective pixels or a small number of light dots on the screen. This is
due to the characteristics of the panel itself, and is not a malfunction of the product.
• The backlight of the LCD panel has a fixed lifetime. When the screen becomes dark or begins
to flicker, please contact your dealer.
• Do not press on the panel or edge of the frame strongly, as this may result in display
malfunctions, such as interference patterns, etc. If pressure is continually applied to the panel,
it may deteriorate or damage your panel. (If the pressure marks remain on the panel, leave
the monitor with a black or white screen. The symptom may disappear.)
• Do not scratch or press on the panel with any sharp objects, as this may result in damage to
the panel. Do not attempt to brush with tissues as this may scratch the panel.
• When the monitor is cold and brought into a room or the room temperature goes up quickly,
dew condensation may occur on the interior and exterior surfaces of the monitor. In that case,
do not turn the monitor on. Instead wait until the dew condensation disappears, otherwise it
may cause some damage to the monitor.