Filter
Top Products
50
The touch switch settings will appear when the above setting has been
made.
8. Set the way in which the display will appear on the screen.
Frame Whether or not a switch frame is to be displayed when the switch
is displayed. If “No” is designated, the switch will be indicated by
dotted lines on the Support Tool display. Either or normal or solid
frame can also be designated.
Inverse Whether an inverse display will appear when the touch switch is
input.
Attributes Specify whether the switch is to light of flash while pressed.
Label Whether or not a label is to be attached to the switch.
Press the Enter Key after completing all of these settings.
9. If you set label to “Yes,” the following screen will be displayed. If you set
label to “No,” you will be returned to the Initial Touch Switch Display.
Input the label and press the Enter Key. You can also press the F3
Function Key to input from a list of marks that have been created. Refer
to page 22 for details on the mark input procedure.
Touch Switches Section 2-5