Filter
Top Products
59
Deleting and Modifying Direct connection bar graphs are deleted or modified from the display shown
in step 1. above. Select the number of the numeral table and then specify
DELETE or MODIFY. The modification procedure is basically the same as
the creation procedure given above.
2-7 Editing Memory Tables
Memory tables can be displayed for editing or to create lists of screen num-
bers referencing a specified table entry. This function is the same when
NEXT, F2 (TBL EDIT) is executed from the Screen Selection Display.
The procedure for editing memory tables depends on whether or not direct
connection is ON or OFF in the Tool Settings. Both procedures are given be-
low.
2-7-1 Normal Operation
If you select TBL EDIT on the Initial Edit Display, the Initial Table Editing Dis-
play will appear.
Initial Table Edit Display
Selecting the Memory Table Select either numeral table or string table for editing.
Editing the numeral table and string table is explained separately below.
Editing Numeral Tables If you select the numeral table to edit, the following display will appear. For
the NT20M, numeral table entries are numbered from 0 to 127, for a total of
128. For the NT600M, numeral table entries are numbered from 0 to 255, for
a total of 256. At first, only the contents of table entries 0 to 63 are displayed
Editing Memory Tables Section 2-7