Filter
Top Products
SETTING THE CLOCK
1. On the URC-8910 remote control,press and hold
SET until you see the display change from the default
device and time to [CODE SET].
NOTE:Default values for device, its code,and time are
shown above.Your remote control settings may be different.
NOTE:If you wish to exit the programming mode at any
time,press
EXIT
once.You will see an
[EXIT]
message as the
remote control returns to normal operation.
NOTE:If you see an
[INVALID]
message,you have inadver-
tently pressed an incorrect key.Simply note your error and
continue programming.
2. Press the ▲ key five times until you see the display
change to [CLOCK SET].
(x 5)
NOTE:If you go past
[CLOCK SET]
,press the
▼
key one or
more times to return to it.
3. Press SELECT once to begin programming.You will
see the display change to the current time.
4. Press the ▲ key one or more times until you see the
desired hour (a.m.or p.m.).
5. Press the ▼ key one or more times until you see the
desired minute.
6. Once the time is correctly set,press SELECT once to
accept the values.The display will confirm your
entry with [SUCCESS] and then [EXIT SETUP].
The URC-8910 remote control will return to
normal operation.
SELECT
SELECT
5