Filter
Top Products
RESTORING FACTORY DEFAULT SETTINGS
The URC-8910 remote control includes an Operation Reset program
that you can use to restore the unit to factory default settings.
IMPORTANT: Executing this program will erase all custom settings,
including Home Theater assignments, Macros,Learned Keys, Keymoved
Keys, and all device assignments.
1. On the URC-8910 remote control,press and hold
SET until you see the display change from the cur-
rent device and time to [CODE SET].
NOTE:The device, its code,and time are examples.Your
remote control settings may be different.
NOTE: To exit programming at any time, press
EXIT
once or
allow 30 seconds of inactivity to lapse.You will see
[EXIT
SETUP]
as the remote control returns to normal operation.
NOTE:
[INVALID]
means you have inadvertently pressed an
incorrect key.Note your error and continue programming.
2. Press the ▲ key twice until you see the display
change to [OPS RESET].
(x 2)
NOTE:If you go past
[OPS RESET]
,press the
▼
key one or
more times to return to it.
3. Press SELECT once to begin programming.You will
see the display change to [CLR SETUP].
4. Press SELECT once to start the process.You will see
the display change to [RESET RAM] as the active
memory is cleared,followed by [RESET E2] as the
preprogrammed memory is restored.
Then you will see [EXIT SETUP] as the URC-8910
remote control automatically exits the programming
mode and returns to normal operation.
SELECT
SELECT
50