Filter
Top Products
5
EN
IR signal check
•
If the remote control is not working
properly, you can use an AM radio or
digital camera (including a cellular
phone with built-in camera) to see if it
is sending out an infrared signal.
• With an AM radio:
Tune the AM radio station to a non-
broadcasting frequency. Point the remote
control towards it, push any button and
listen. If the sound from the radio flutters, it
is receiving the remote control’s infrared
signal.
• With a digital camera
(including built-in cell phone
cameras):
Point a digital camera towards the
remote control. Push any button on
the remote control and look through
the digital camera. If the infrared light
appears through the camera, the
remote control is working.
Copyright
• It is forbidden by law to copy, broadcast, show,
broadcast on cable, play in public, or rent copyrighted
material without permission. Commercial BD-video/
DVD-video discs are copy-protected, and any recordings
made from these discs will be distorted. This product
incorporates copyright protection technology that is
protected by U.S. patents and other intellectual
property rights. Use of this copyright protection
technology must be authorized by Macrovision, and is
intended for home and other limited viewing uses only
unless otherwise authorized by Macrovision. Reverse
engineering or disassembly is prohibited.
Supplied Accessories
remote control with
batteries (AAx2)
RCA audio / video cables
instruction manual
Instruction Manual
quick start guide
Note about Recycling
• This unit’s packaging materials are recyclable and
can be reused. Please dispose of any materials in
accordance with your local recycling regulations.
• Batteries should never be thrown away or
incinerated but disposed of in accordance with your
local regulations concerning chemical wastes.
Maintenance
Servicing
• Please refer to relevant topics on “TROUBLESHOOTING” on
page 50 before returning the product.
• If this unit becomes inoperative, do not try to correct the
problem by yourself. There are no user-serviceable parts
inside. Turn the unit to the standby mode, unplug the
power plug, and please contact your Onkyo dealer.
Disc handling
•
For best results, keep your discs clean. Fingerprints and dust
can affect the sound and picture quality and should be
removed as follows. Using a clean, soft cloth, wipe from the
center outwards, as shown. Never wipe in a circular direction.
• To remove stubborn dust or dirt, wipe the disc with a
damp, soft cloth, and then dry it with a dry cloth.
• Never use solvent-based cleaning fluids, such as thinner
or benzine, commercially available cleaners, or antistatic
sprays intended for vinyl records, because they may
damage the disc.
PRECAUTIONS