Filter
Top Products
37
First Edit Function
(Preparing the editing tape)
The CTL (control) signal must be recorded ahead of time onto the editing tape. The method
used to record it differs depending on whether assemble editing or insert editing is to be
performed.
The “E-00” servo lock error appears on the tape counter when insert editing is performed for a
tape on which the CTL signal has not been recorded.
When insert editing is performed, the CTL signal must be recorded ahead of time.
<Note>
When first edit is to be performed, operation can be conducted by connecting the RS-232C
remote control (AJ-A250), which is available as an optional accessory. However, control using
the RS-232C interface (EFE command) can also be exercised from a computer.
(See page 50)
First edit for assemble editing
In the case of a tape for assemble editing, the CTL signal is recorded at the beginning of where
the recording is to be commenced.
–23 sec. position 0 sec. position
3 sec.
Direction of tape
travel
CTL signal recording
Position where CTL signal recording starts
First edit for insert editing
In the case of a tape for insert editing, the CTL signal is recorded from the beginning of where
the recording is to be commenced to the end.