Filter
Top Products
75
2
3
4
34
1
5
Emergency Eject
Procedure for removing the tape manually in an emergency
Use the procedure below to remove the cassette tape if it can not be removed even when the EJECT button is
pressed.
O
Before proceeding to eject the tape manually, you must first turn off the power to the unit.
1
Remove the top panel.
2
Use a Phillips head screwdriver to push in and turn
the red plastic screw part counterclockwise.
(This screw needs to be rotated about 30 turns
before unloading can be started.)
3
Insert the take-up jig (packed with the unit) into the
tape ejection slot (on the mechanism side of the
VTR), and rotate the flange part (white gear) of the
supply reel in the take-up direction using the
rubber part of the take-up jig to take up the tape
slack.
<Note>
Take care not to damage the tape in any way.
4
Use the Phillips head screwdriver to push in and
turn the red plastic screw part counterclockwise
once more. Again rotate the flange part of the
supply reel in the take-up direction to take up the
tape slack.
This two-step procedure needs to be repeated until
the tape is completely housed in the cassette case
(about 90 turns of the red plastic screw part).
5
Use the Phillips head screwdriver to turn the red
plastic screw part at the slot-in side clockwise to
eject the cassette tape.
(This screw needs to be rotated through about 140
turns until the tape is ejected.)
<Note>
Take care not to sandwich or catch the tape when
closing the cassette cover.