Filter
Top Products
67
RS-232C
$
Search control commands
Sends data of computer Return data from VTR Description of command
[STX] SMP:data [ETX]
Parameters
data = pww:ghmmssff
O
When the counter value is to
be stored in the memory
p = B: BEGIN point
E: END point
ww = LC: CTL data reference
SC:TC data reference
“ghmmssff” is omitted.
O
When the parameter value for
which the CTL data serves as
the reference is to be stored in
the memory
p = B: BEGIN point
E: END point
ww = LP: CTL data reference
g = Blank: With a positive value
– sign: With a negative value
h = 0
9: Hours
mm = 00 59: Minutes
ss = 00 59: Seconds
ff = 00 29: Frames
O
When the parameter value for
which the TC data serves as
the reference is to be stored in
the memory
p = B: BEGIN point
E: END point
ww = SP: TC data reference
gh = 00
23: Hours
mm = 00 59: Minutes
ss = 00 59: Seconds
ff = 00 29: Frames
O
When the designated position
is not to be entered
data =
BN: No entry of BEGIN point
EN: No entry of END point
[STX] SMP [ETX] Sets the repeat position.
When the BEGIN point and END point have been
designated in different modes, they are converted inside the
VTR and set in the mode which was last designated.
Parameter “ff” is processed as “00” inside the VTR.
<Note>
This command is ignored while a search control command
is being processed.