Filter
Top Products
– 52 –
Setup menus
USER menu
<EDIT>
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
300 VAR 0000 – .43~1
RANGE
0001 – 4~+4
301 IN/OUT 0000 MANU
DEL
0001 AUTO
302 NEGA 0000 OFF
FLASH 0001 ON
303 STD/ 0000 AUTO
NON-STD 0001 STD
0002 N-STD
304 SERVO 0000 AUTO
REF 0001 EXT
305 EDIT 0000 N-DEF
RPLCE1
0001 CH1
0002 CH2
0003 CH1+2
306 EDIT 0000 N-DEF
RPLCE2 0001 CH1
0002 CH2
0003 CH1+2
307 EDIT 0000 N-DEF
RPLCE3 0001 CH1
0002 CH2
0003 CH1+CH2
The underline on the setting item denotes the initial setting.
This sets the VAR speed range.
0: The tape is played in slow motion at a speed ranging from
–0.43× to +1× normal speed.
1: The tape is played in the ±4.1× normal speed range.
This selects the operation to be performed when an edit point
has been set incorrectly (when the OUT point is before the IN
point).
0: Editing is not executed unless the illegal edit point is
cleared or set again properly.
1: The edit points already input are automatically cleared.
This selects whether to show a negative display when the IN
point is greater than the OUT point.
0: No negative display.
1: Negative display.
This selects STD or NON-STD in accordance with the compo-
site input signal.
0: Standard/non-standard signals are automatically identified
and processed.
1: Standard signals are processed. (Forced STD)
2: Non-standard signals are processed. (Forced NON-STD)
This selects the video signal processing.
0: Servo is synchronized with the input signal during recording
and editing, or with the REF signal during playback.
1: Servo is synchronized at all times with the REF signal.
This sets the channel assignments for the controller’s analog
audio preset when editing the digital audio of the VTR using a
controller which does not have a digital audio edit preset
control function.
This selects the channel concerned when the VTR CH1 edit
preset is set in compliance with the ON or OFF presetting for
the analog audio signals designated by the controller.
0: Not set.
1: Compliance with analog CH1 edit preset.
2: Compliance with analog CH2 edit preset.
3: Compliance with either analog CH1 ot CH2 edit preset.
This selects the channel concerned when the VTR CH2 edit
preset is set in compliance with the ON or OFF presetting for
the analog audio signals designated by the controller.
0: Not set.
1: Compliance with analog CH1 edit preset.
2: Compliance with analog CH2 edit preset.
3: Compliance with either analog CH1 ot CH2 edit preset.
The same type of setting as No. 305. This selects the channel
concerned when the VTR CH3 edit preset is set in compliance
with the On or OFF presetting for the analog audio signals
designated by the controller.
0: Not set.
1: Compliance with analog CH1 edit preset.
2: Compliance with analog CH2 edit preset.
3: Compliance with either analog CH1 or CH2 edit preset.