Filter
Top Products
27
Timer recording (continued)
To check programmes
[RAM] [DVD-R]
Press [PROG/CHECK] (13).
The Timer Programme List screen appears.
Icon explanations (A)
¥ This programme is currently recording.
W The programme is overlap with another programme.
F The disc was full or the maximum number of programmes or
scenes was reached so the programme failed to record.
The television programme was copy-guarded so the
programme failed to record.
TV system of the programme is different from the setting in
SETUP, so the programme failed to record.
X The programme did not complete recording because the
disc is dirty or some other reason.
Disc space
OK: Displayed if the recording can fit in the remaining
space on the disc.
# (Date): For recordings made daily or weekly, the display
will show until when recordings can be made
based on the time remaining on the disc.
!: Displayed if the disc is not inserted in the unit or is
write-protected (pages 30 and 64) or there is not
enough memory capacity left on the disc.
ªTo change the programme
(page 26)
ªTo exit from the Timer Programme List screen
Press [PROG/CHECK] (13) or [RETURN] (23). (The television is
shown.)
For your reference
≥Programmes that failed to record are deleted from the list at 4
a.m. the day after tomorrow.
Starting and canceling programmes
[RAM] [DVD-R]
ªTo put the unit on recording standby
Press [ , TIMER] (12).
The unit turns off and “ ” lights on the unit’s display.
Note
≥The unit cannot go to timer recording standby if the disc is
protected (pages 30 and 64) or full (“ ” flashes). Check the disc
carefully.
ªTo release the unit from recording standby
If you want to record something else before the programme start
time, for example:
Press [ , TIMER] (12).
The unit turns on and “ ” goes out.
≥Be sure to press [ , TIMER] (12) before the programme start
time to put the unit on recording standby. The programme only
works if “ ” is on.
ªTo stop recording while a programme is working
Press [ , TIMER] (12).
To clear a timer recording programme
[RAM] [DVD-R]
Press [CANCEL] (5) or [ERASE] (30) while the
programme’s Timer Programme Correction screen is
being shown.
(Alternatively, use [3, 4] (10) to select the programme
in the Timer Programme List screen and press
[CANCEL] (5) or [ERASE] (30).)
≥You can not delete programmes that are currently recording.
RETURN
SELECT
1:2264 ABC 12/ 7 TUE01 SP
Mode
Disc
space
Stop
1:19
StartNo.
Name
Date
1:58 SP
TIMER
RECORDING
Remain
1:19:00 12.7 TUE
ENTER
CANCEL
02
03
04
05
64 ABC
64 ABC
64 ABC
64 ABC
12/ 7
TUE
20/ 7
WED
20/ 7
WED
20/ 7
WED
1:20
8:00
9:00
10:00
2:20
9:00
10:00
11:00
SP
SP
SP
SP
OK
OK
OK
OK
OK
W
F
X
New Timer Programme
A
DVD(PAL).book 27 ページ ２００３年５月２２日 木曜日 午後１２時３分