Panasonic DMR-E51 DVD Recorder User Manual


 
66
Troubleshooting guide (continued)
Displays
Play
Remote control
The display is dim. Go to Display in the SETUP menus and change the display’s brightness with “FL Display”.
(page 53)
“0:00” is flashing on the unit’s
display.
The clock is not set.
Go to Settings in the SETUP menus and set the clock with “Clock”. (page 56)
“NO READ” appears on the unit’s
display after using a lens cleaner.
Take the cleaner out of the unit.
Play fails to start even when [1]
(21) is pressed.
Play starts but then stops
immediately.
“NO READ”, “UNSUPPORT”, “NO
DISC” or “NO PLAY” appears on
the unit’s display.
Insert the disc correctly with the label facing up. (page 13)
This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Video, Video CD, CD and MP3
disc. (page 8)
The disc is dirty. Clean it. (page 60)
The disc may be badly scratched. (page 60)
You inserted a blank DVD-RAM or DVD-R.
No response when buttons
pressed.
If “ ” appears on the television
the operation is prohibited by the unit or disc.
If the unit is not operating at all, press [ , TIMER] (12) to switch the unit to standby, then press
[,TIMER] (12) again to turn the unit on. The unit may not be operating correctly due to
lightning, static electricity, or some other external factor.
The Child Lock function is activated. (page 46)
A title or chapter doesn’t play
when it is selected.
Some titles and chapters on DVD-Video are not played when you have changed the ratings
level. (page 54)
Picture distorted during search. Some distortion is normal.
Alternative soundtrack and
subtitles cannot be selected.
The languages are not recorded on the disc.
You may have to use the disc’s own menus to select languages.
Soundtrack/subtitle language not
the one selected with the SETUP
menus.
The language is not recorded on the disc. (page 51)
No subtitles. Subtitles are not recorded on the disc.
Turn the subtitles on. (page 43)
Angle cannot be changed. This function depends on software availability. Angles can only be changed during scenes where
different angles are recorded (“ ” appears on the display).
You have forgotten your ratings
password.
Return the unit's settings to the initial state (factory setting).
With the tray open, keep pressing [:/6] and [5/9] (42) on the main unit
simultaneously for 5 or more seconds.
The remote control doesn’t work.
The unit is on standby to make a timer recording (“ ” on the unit’s display is on). (page 24)
[DVD, TV] (15) is not switched to “DVD”.
Switch to “DVD” when operating this unit. (page 7)
The remote control code is wrong.
Change to the correct code. (page 55)
The batteries are depleted. Replace them with new ones. (page 7)
Point the remote control at the remote control sensor on the main unit. (page 7)
Remove obstacles from between the remote control and main unit.
The Child Lock function is activated. (page 46)
Cannot operate the television. The remote control code is wrong.
Change to the correct code. Some televisions cannot be operated even if you change the code.
(page 7)
[DVD, TV] (15) is not switched to “TV”.
Switch to “TV” when operating the television. (page 7)
DVD(PAL).book 66 ページ 2003年5月22日 木曜日 午後12時3分