Panasonic DMR-E51 DVD Recorder User Manual


 
63
Self-diagnosis
The self-diagnosis displays appear if a problem occurs with the unit.
The service numbers in the table appear when a problem occurs.
The service numbers are a “U” followed by two digits.
Service
number
Unit status Solutions
NO READ The disc is dirty or badly
scratched.
Follow the instructions in “Maintenance and Handling” to clean the disc if it is dirty.
(page 60)
The disc cannot be played if it is scratched and this display doesn’t disappear.
It can not be read for the
disk which doesn’t cope
with it.
It can not be read for the disk which doesn’t cope with it. Exchange a disk.
The DVD-RAM/PD lens
cleaner has finished
cleaning.
Take the cleaner out of the unit.
UNSUPPORT You have inserted a disc
the unit cannot play or
record on.
Insert a disc the unit can play or record on. (page 8)
U14 The unit is hot. The unit switches to standby automatically for safety reasons and you cannot operate it.
Wait for about 30 minutes for the service number to disappear.
Select a position with good ventilation when installing the unit.
Do not block the cooling fan on the rear of the unit.
U99 The unit fails to operate
properly.
Press [Í/I] (1) to switch the unit to standby. Now press [Í/I] (1) again to turn the unit
on.
REMOTE
DVD
The remote control code is
wrong.
Change to the correct code. (page 55)
RECOVER A power failure occurred
or the AC mains plug was
disconnected while the
power was ON.
The unit is carrying out its recovery process. Wait until the message disappears.
Service number
DVD(PAL).book 63 ページ 2003年5月22日 木曜日 午後12時3分