Filter
Top Products
RQT9053
12
STEP 1 Connection
Leave “Yellow” unconnected.
The S VIDEO OUT terminal achieves a more vivid picture than the
VIDEO OUT terminal. (Actual results depend on the television.)
COMPONENT VIDEO OUT terminals can be used for either
interlace or progressive output (Ô 50) and provide a purer picture
than the S VIDEO OUT terminal.
Connect to terminals of the same colour.
If you have a regular television (CRT: cathode ray tube)
Progressive output may cause some flickering, even if it is
progressive compatible. Turn off “Progressive” if you are concerned
about it (Ô 27). This is the same for multi system televisions using
PAL mode.
n Connecting an amplifier with a digital input
terminal
• To enjoy multi-channel surround sound DVD-Video, connect an
amplifier with Dolby Digital, DTS and MPEG decoders.
“Digital Audio Output” in the Setup menu (Ô 38)
• Before purchasing an optical digital audio cable, check the terminal
shape of the connected equipment.
• You cannot use DTS Digital Surround decoders not suited to DVD.
n Connecting a stereo amplifier
Other connections
Connecting a television with S VIDEO terminals
AUDIO IN
R L
VIDEO
IN
COMPONENT
VIDEO IN
S VIDEO
IN
Television’s rear panel
Audio/video cable
(included)
S Video cable
This unit’s rear panel
Red White
Red White
Connecting a television with COMPONENT VIDEO terminals
AUDIO IN
R L
VIDEO
IN
COMPONENT
VIDEO IN
S VIDEO
IN
Television’s rear panel
Audio/video cable
(included)
Video cable
This unit’s rear panel
Red White
Red White
“Progressive” setting in the Setup menu (Ô 39)
Required setting
COMPONENT
VIDEO OUT
COMPONENT
VIDEO IN
This unit
Progressive output
CRT
DO NOT
Connecting an amplifier or system component
Required setting
OPTICAL IN
Do not bend
cable sharply.
Insert fully,
with this
side up.
This unit’s rear panel
Amplifier’s rear panel
Optical digital
audio cable
AUDIO IN
R L
Amplifier’s rear panel
This unit’s rear panel
Audio cable
Red White
Red White
RQT9053-L.book 12 ページ ２００８年６月３０日 月曜日 午後１時２３分