Filter
Top Products
RQT9053
49
Edit Page
Cannot format. • The disc is dirty. Wipe with a damp cloth and then wipe dry.
• You tried formatting a disc that is not compatible with this unit.
5
6, 7
Cannot create chapters.
Cannot mark the start point
or the end point during
“Partial Delete” operation.
• The unit writes the chapter information to the disc when you turn it off or remove the disc. The
information is not written if there is an interruption to the power before this.
• These operations are not possible with still pictures.
• You cannot set points if they are too close to each other. You cannot set an end point before a start
point.
—
—
—
Cannot delete chapters. • When the chapter is too short to delete, use “Combine Chapters” to make the chapter longer. 31
The available recording
space doesn’t increase
even after deleting
recordings on the disc.
• Available recording space on DVD-R, DVD-R DL, +R or +R DL does not increase even after
deleting previously recorded titles.
• Available recording space on DVD-RW (DVD-Video format) or +RW increases only when the last
recorded title is deleted. It does not increase if other titles are deleted.
—
—
Cannot create a playlist. • You cannot select all the chapters at once in a title if the title also includes still pictures. Select
them individually.
—
Still pictures
Cannot display Direct
Navigator screen.
• This screen cannot be displayed during recording or copying. —
Still pictures (JPEG) are
not played back properly.
• The images that were edited on the PC, such as Motion JPEG, Progressive JPEG, etc., may not
be played back.
25
To reset this unit
To return all the settings
other than the main ones to
the factory preset.
• Select “Yes” in “Shipping Condition” in the Setup menu. All the settings except for the ratings level,
ratings password and time settings return to the factory preset. The timer recording programmes
are also cancelled.
• Select “Yes” in “Default Settings” in the Setup menu. All the settings other than the programmed
channels, time settings, disc language settings, ratings level, ratings password, remote control
code, return to the factory presets.
• Press and hold [2 CH] and [CH 1] on the main unit until the Auto-Setup screen appears. All the
settings except for the ratings level, ratings password and time settings return to the factory preset.
The timer recording programmes are also cancelled.
40
40
—
To reset the ratings level
settings.
• While the disc tray is open, press and hold [* REC] and [q/x1.3] on the main unit at the same time
for 5 or more seconds.
—
To restore the unit if it
freezes due to one of the
safety devices being
activated.
• Press and hold [8] on the main unit for 10 seconds. (The settings remain.) —
Troubleshooting guide
RQT9053-L.book 49 ページ ２００８年６月３０日 月曜日 午後１時２３分