Panasonic DMR-ES18 DVD Recorder User Manual


 
RQT9053
44
Messages
On the unit’s display
The following messages or service numbers appear on the unit’s display when something unusual is detected during startup and use.
Page
DVD
(“ ” stands for a number.)
The remote control and main unit are using different codes. Change
the code on the remote control.
Press and hold [OK] and the indicated number button at the same
time for more than 5 seconds.
40
HARD ERR
If there is no change after turning the unit on and off, consult the dealer where the unit was
purchased.
NoERAS Deleting an item may be unavailable due to a disc problem. Use a new disc.
NoREAD The disc is dirty or badly scratched. The unit cannot record, play, or edit.
The message may appear when the DVD lens cleaner has finished cleaning.
Press [; OPEN/CLOSE] on the main unit to eject the disc.
5
5
NoWRIT Recording may be unavailable due to a disc problem. Use a new disc.
The unit’s “TV System” setting differs from the TV system used by the disc. Change the “TV
System” in the Setup menu.
39
PLEASE WAIT
Displayed when the unit is started. This is not a malfunction.
The unit is carrying out its recovery process. You cannot operate the unit while “PLEASE
WAIT” is displayed.
PROG FULL
There are already 16 timer programmes. Delete unnecessary timer programmes. 19
UNFORMAT
You inserted an unformatted DVD-RAM, DVD-RW, +RW, an unused +R, +R DL or DVD-RW
(DVD-Video format) that has been recorded on other equipment.
Format the disc to use it.
However all the recorded contents on the disc are deleted.
35
UNSUPPORT
You have inserted a disc the unit cannot play or record on. 6, 7
U59 The unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the message
disappears.
Select a position with good ventilation when installing the unit. Do not block the cooling fan
on the rear of the unit.
U61 The unit detected an error while recording or playing with no disc in the disc tray. The unit is
carrying out its recovery process. This process restores the unit to normal operation. The
unit is not broken. Wait until the message disappears.
U80
U81
U99
The unit fails to operate properly. Press [8] on the main unit to switch the unit to standby
mode. Now press [8] on the main unit again to turn the unit on.
U88 The unit detected an error while recording or playing with a disc in the disc tray. The unit is
carrying out its recovery process. This process restores the unit to normal operation. The
unit is not broken. Wait until the message disappears.
47
H or F
There is something unusual. (The service number displayed after H and F depends on the
unit’s condition.)
Check the unit using the troubleshooting guide. If the service number does not disappear, do
the following.
1. Disconnect the plug from the household mains socket, wait a few seconds, then reconnect
it.
2. Press [8] to turn the power on. (The unit may be fixed.)
If the service number does not disappear despite after doing the above, request service from
the dealer. Inform the dealer of the service number when requesting service.
46-49
XHOLD The Child Lock function is activated.
Press and hold [OK] and [RETURN] simultaneously until “X HOLD” disappears.
41
The messages are alternately displayed.
RQT9053-L.book 44 ページ 2008年6月30日 月曜日 午後1時23分