Filter
Top Products
RQT8317
10
STEP 1 Connection
The S VIDEO OUT terminal achieves a more vivid picture than the
VIDEO OUT terminal. (Actual results depend on the television.)
COMPONENT VIDEO OUT terminals can be used for either
interlace or progressive output (Ô page 50) and provide a purer
picture than the S VIDEO OUT terminal.
• Connect to terminals of the same colour.
If you connect a CRT (cathode ray tube) television
Use component output with progressive “Off” (Factory setting,
Ô page 40), even if it is progressive compatible, because
progressive output can cause some flickering. This is the same for
multi system televisions using PAL mode.
n Connecting an amplifier with a digital input
terminal
• To enjoy multi-channel surround sound DVD-Video, connect an
amplifier with Dolby Digital, DTS and MPEG decoders.
“Digital Audio Output” in the Setup menu (Ô page 40)
• Before purchasing an optical digital audio cable, check the terminal
shape of the connected equipment.
• You cannot use DTS Digital Surround decoders not suited to DVD.
• Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
n Connecting a stereo amplifier
Other connections
Connecting a television with S VIDEO terminals
AUDIO IN
R L
VIDEO
IN
COMPONENT
VIDEO IN
S VIDEO
IN
Television’s rear panel
Audio/Video cable
(included)
S Video
cable
This unit’s rear panel
Red White
Red White
Connecting a television with COMPONENT VIDEO terminals
AUDIO IN
R L
VIDEO
IN
COMPONENT
VIDEO IN
S VIDEO
IN
Television’s rear panel
Audio/Video cable
(included)
Video cable
This unit’s rear panel
Red White
Red White
COMPONENT
VIDEO OUT
COMPONENT
VIDEO IN
This unit
Progressive output
CRT
Connecting an amplifier or system component
Required setting
OPTICAL IN
Optical digital audio cable
Do not bend this cable sharply.
Insert fully, with this side facing up.
This unit’s rear panel
Amplifier’s rear panel
AUDIO IN
R L
Amplifier’s rear panel
This unit’s rear panel
Audio cable
Red White
Red White