Filter
Top Products
RQT8317
18
Timer recording
See also the notes “Important notes for recording” (Ô page 14).
Preparation
• Turn on the television and select the appropriate video input to suit
the connections to this unit.
• Check the time on the unit is correct.
• Insert a disc (Ô page 16).
Entering G-
CODE numbers is an easy way of timer recording. You can
find these numbers in TV listings in newspapers and magazines.
• You can enter up to 16 programmes up to a month in advance.
1 Press [G-Code].
2 Press the numbered buttons to enter
the G-CODE number.
• To correct the number
Press [w] to move back to correct a digit.
3 Press [ENTER].
• Confirm the programme and make corrections if necessary
using [e,r,w,q] (Ô page 19, Manually programming timer
recordings, step 3).
• When “––––” appears in the “Name” column, you cannot set
timer recording. Press [e,r] to select desired programme
position. After you have entered the information of a TV
station, it is kept in the unit’s memory.
• You can also press [REC MODE] to change the recording
mode.
• To enter programme name
Press [w,q] to select “Programme Name” and press
[ENTER] (Ô page 35).
4 Press [ENTER].
The settings are stored and the programme goes to timer
recording standby.
The timer icon is displayed in left column.
“z” lights on the unit’s display to indicate timer recording
standby has been activated.
Repeat steps 1–4 to programme other recordings.
n To cancel recording when recording has already
begun (Ô page 20)
n Notes on timer recording (Ô page 20)
To exit the timer recording list
Press [PROG/CHECK].
G-
CODE is a registered trademark of Gemstar
Development Corporation. The G-
CODE
system is manufactured under license from
Gemstar Development Corporation.
Numbered
buttons
e,r,w,q
ENTER
G-Code
REC MODE
PROG/CHECK
e.g.,
Australia and N.Z.
RAM -R -R DL -RW(V) +R +R DL +RW
For Australia and N.Z.
Using G-CODE system to make timer
recordings
For Australia and N.Z.
CANCEL
S
SUB MENU
G-Code
Record
Remain
8:12:34 7. 5. SUN
1:57 SP
Input G-Code Number 0-9, and press ENTER.
ENTER
RETURN
Number
--
0 9
Timer
Recording
Remain
8:14:56 7. 5. SUN
1:57 SP
Programme Name
Name Date Start Stop Mode
7. 5. SUN 19:00 20:00 SP1 ARD
Timer
Recording
NameNo.
ARD01
Timer icon
NameNo. Date
7. 5. SUN
Start
19:00
New Timer Programme
Stop
20:00
Mode
SP
Drive
space
OKARD01
When “!” appears,
make sure the
disc has a
sufficient space.