Filter
Top Products
38
Remote control setting
Remote Control Operation is possible for the Panasonic VCR’s and DVD’s equipment.
After completion of setting, execute the various operations after pressing the VCR / DVD selection switch.
Switch to select VCR or DVD.
While pressing the VCR / DVD Power button, press the manufacturer code
(enter the two digit code), and press the VCR / DVD Stop button.
Notes:
• After setting, execute operation confi rmation. If there is no operation, set a different code.
• The respective VCR / DVD code is cancelled when battery has been exchanged. Please set it again.
• Depending on the model, operation may not be possible.
• In some cases, new products may not be operative.
VCR DVD
OK
123
456
789
0
123
456
789
0
Stereo / Bilingual Sound Selection
When you receive the stereo / bilingual sound system, sound output modes can be selected by pressing
the Stereo / Bilingual Sound Selection button.
Notes:
• If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic switching
occurs, it is recommended you switch from STEREO to MONO.
• Even when the contents of the receiving signal undergo changes, selection mode is kept intact.
• When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO position, using the
stereo / bilingual sound selection button.
• DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.
VCR
Manufacturer Code
Panasonic/ National 10,11,12,13
DVD
Manufacturer Code
Panasonic 70, 71
Audio Signal STEREO
MAIN
I
SUB
II
MONO
Mode Indicator
I II
NICAM .......Used in New Zealand, Singapore, Hong Kong etc.
Type of broadcast
Regular broadcast
(Standard Audio)
Regular + NICAM MONO
I
(MAIN
I
)
NICAM STEREO
NICAM DUAL MONO
(MAIN
I
/ SUB
II
)
Mode Indicator
No Indicator
I
I
II
A2(German) .......Used in Australia, Malaysia etc.
Type of broadcast
Regular broadcast
(Standard Audio)
BILINGUAL or DUAL MONO:
MAIN
I
/ SUB
II
STEREO
Mode Indicator
No Indicator
III