Filter
Top Products
Cable Connection
Connecting the Aerial cable to the RF In Terminal
• For proper reception of VHF/UHF channels, an external antenna is required. For best reception, an outdoor antenna is
recommended. Antenna Mode must be set to TV.
• Incoming Cable from Home Antenna
Connect home antenna to ANT1 connection on back of television. Select TV mode and ANT1 in the SET UP menu.
( Cable Mode is preset at the factory. Antenna users must change to TV mode and select ANT1 in the Set Up Menu.)
VHF Aerial UHF Aerial
Mixer
75 Ohm /
Coaxial Cable
1an
Incoming Cable from
Home Antenna
Incoming Cable from
Cable Company
Ferrite core (large size)
(supplied)
Less than Less than Note: Certain cable systems offset some channels
i i
4" (10 cm):÷ _ 4" (10 cm) :÷ to reduce interference or have Premium
, (scrambled) channels. A cable converter box
is required for proper reception. Check with
_)4"= _) your local Cable company for its compatibility
_ \\\ requirements.
F-Type Antenna \\ 75 Ohm VHF/UHFJ
Adapter (supplied) \\ on back of TV
\ /
Ferrite core (large size)
Notes: (supplied)
(1) To obtain optimum quality picture and sound, an Aerial, the correct cable (75 Ohm coaxial) and the correct terminating
plug are required.
(2) If a communal Aerial system is used, you may require the correct connection cable and plug between the wall Aerial
socket and your television receiver.
(3) Your local Television Service Centre or Dealer may be able to assist you in obtaining the correct Aerial system for your
particular area and the accessories required.
(4) Any matters regarding Aerial installation, upgrading of existing systems or accessories required, and the costs incurred,
are the responsibility of you, the Customer.
Connecting Headphones / Earphones
Connect headphones / earphones as follows.
12
(M3 plug)
Ferrite core (small size)
(supplied)
Less than
4" (10 cm)
tional)
Jl
-f
You can listen to sound from the headphone Jack.