Filter
Top Products
Cable Connection
PC Input Terminals connection
COMPUTER
Ferrite core (small size)
(supplied)
Audio
Less than
I
4" (10 cm)
I
Stereo plug
Connect a cable which matches
the audio output terminal on the computer.
Conversion adapter Less than Lessthan
(if necessary) _I 4" (10 cm) ' ' 4" (10 cm) '
RGB
\ PC cable
_ / D-sub 15p
Ferrite core (large size)
(supplied)
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the imagewill not be displayed properlyifthe signals exceed 1,200 lines.)
(2) The display resolution is a maximum of 768 x 768 dots (TH-42PX20), 1,024 x 768 dots (TH-50PX20) when the
aspect mode is set to "4:3", and 1,024 x 768 dots (TH-42PX20), 1,366 x 768 dots (TH-50PX20) when the aspect
mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible to show fine detail
with sufficient clarity.
(3) Some PC models cannot be connected to the set.
(4) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(5) The computer shown in the illustration is for example purposes only.
(6) Additional equipment and cables shown are not supplied with this set.
(7) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
f
Pin Layout for PC Input
Terminal
Pin No.
®
®
®
Signal Name Pin No. Signal Name
R ® GND (Ground)
G _) GND (Ground)
B ® GND (Ground)
NC (notconnected ® NC(notconnected)
GND (Ground) @ GND (Ground)
Pin No.
@
@
@
@
@
Signal Name
NC (notconnected)
NC
HD/SYNC
VD
NC
18