Filter
Top Products
27
Input signal that can be displayed
Control with VIERA Link
HDMI connections to some Panasonic equipment allow you to enjoy the easy playback.
Setup the equipment to enable this function. Read the manual of the equipment.
Switch the TV until on again with the equipment on when connection or setup is changed.
This function may not work normally depending on the equipment condition.
The equipment can be operated by TV’s remote control with this function on even if TV is in Standby
mode.
Image or sound may not be available for the first few seconds when the playback starts.
Image or sound may not be available for the first few seconds when the input mode is switched.
Easy playback is also available by using the remote control from Amplifier or Player theatre.
Read the manual of the equipment.
Mark : Applicable input signal for Component (Y, P
B/CB, PR/CR) and HDMI
Signal name Horizontal frequency (kHz) Vertical frequency (Hz) Component HDMI
525 (480) / 60i 15.73 59.94
**
525 (480) / 60p 31.47 59.94
**
625 (576) / 50i 15.63 50.00
**
625 (576) / 50p 31.25 50.00
**
750 (720) / 60p 45.00 60.00
**
750 (720) / 50p 37.50 50.00
**
1,125 (1,080) / 60i 33.75 60.00
**
1,125 (1,080) / 50i 28.13 50.00
**
Note
Signals other than the above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.
Applicable input signal for PC is basically compatible to VESA standard timing.
PC signal is magnified or compressed for display, so that it may not be possible to show fine detail with
sufficient clarity.
Signal name Horizontal frequency (kHz) Vertical frequency (Hz)
640 × 480 @60 Hz 31.47 59.94
800 × 600 @60 Hz 37.88 60.32
852 × 480 @60 Hz 31.47 59.94
1,024 × 768 @60 Hz 48.36 60.00
1,366 × 768 @60 Hz 48.39 60.04
PC (D-sub 15P)
TX-26LE8A_0091_EN1.indd 27TX-26LE8A_0091_EN1.indd 27 7/16/08 2:21:47 PM7/16/08 2:21:47 PM