Filter
Top Products
Pelco Manual C671M (1/01) 17
5. MENU/TIME DATE ADJUST button
• When the VCR is turned on, press to display the Main menu. Press again to exit
the menu.
• When the VCR is turned off, press for more than three seconds and you can
adjust the VCR’s time and date on the fluorescent display.
6. PLAY/REC CHECK button
• When the VCR is in stop mode, press to play back a previously recorded tape.
• During recording, press for more than 1.5 seconds to check recording function.
7. STOP button
Press to halt all tape-related functions.
8. PICTURE control
Use this control to adjust picture quality between soft and sharp.
9. REC/PLAY MODE buttons
Set to 8H, L24H, or L40H for recording, and to 2H, 8H, L24H, or L40H for playback.
10. TRACKING buttons (+/-)
Press to reduce or eliminate the noise during playback, slow playback, etc.
11. POSITION/VERTICAL ADJUST buttons (+/-)
• Pressing the (+) button moves the time and date display to the right. Pressing the
(-) button moves the display down the screen. The display cannot be adjusted
during an alarm recording or if a warning is displayed.
• Pressing either button minimizes vertical jitter in still mode or during fast
playback. Refer to the
Vertical Adjustment
section for details.
12. EJECT button
Press to remove the cassette.
13. REC (record) button
Press to begin recording.
14. COUNTER RESET button
Press to reset the counter to 00000.
15. SEARCH button
Press to access the Search Function menu.
16. TIMER REC button
Press to make a timed recording (once the VCR is programmed to record).
17. PAUSE/SHUTTLE HOLD button
• Press during recording to temporarily stop tape movement. Press again to
resume recording.
• Press during playback for a still picture. Press again to resume normal playback.
• Press and hold after turning the SHUTTLE ring to fix the playback speed.