Filter
Top Products
Pelco Manual C671M (1/01) 37
Series Recording 1
When the tape in the first VCR reaches the end during recording or an error occurs on the
VCR, the tape in the second VCR automatically begins recording.
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select REAR TERMINAL, and then turn the SHUTTLE ring right.
The Rear Terminal menu appears.
3. (Perform this step and step 4 on the first VCR only.) When the cursor is next to CALL
OUT, turn the SHUTTLE ring right.
4. Turn the JOG dial to select WRNG•TAPE END, and then turn the SHUTTLE ring right.
5. (Perform this step and step 6 on the second VCR only.) Turn the JOG dial to select
REC IN, and then turn the SHUTTLE ring right.
6. Turn the JOG dial to select SERIES and turn the SHUTTLE ring right.
7. Press the MENU button. The day and time display appears.
Series Recording 2
When the first VCR’s tape reaches its end, the second VCR automatically begins recording.
When the second VCR’s tape reaches its end, the first VCR starts recording again. The two
keep recording one after the other. Set up both VCRs as follows:
1. Perform steps 1 through 6 in the
Series Recording 1
section above.
2. Turn the SHUTTLE ring left. The Main menu appears.
3. Turn the JOG dial to select CLOCK/FIRST TIME SET UP, and then turn the SHUTTLE
ring right. The First Time Set Up menu appears.
4. Turn the JOG dial to select TAPE END, and then turn the SHUTTLE ring right.
5. Turn the JOG dial to select REWIND, and then turn the SHUTTLE ring right.
6. Press the MENU button. The day and time display appears.
REMOTE RECORDING
This function lets you control the start and end of recording from a remote location. The
VCR starts recording when the REC IN terminal is grounded. Refer to Figure 5 for the
remote recording connection.
An index signal is not recorded during remote recording.
Series and timer recording cannot be used simultaneously with remote recording.
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select REAR TERMINAL, and then turn the SHUTTLE ring right.
The Rear Terminal menu appears.
3. Set REC IN to REC-START/STOP.
4. Press the MENU button. The day and time display appears on screen.