Filter
Top Products
44 Pelco Manual C671M (1/01)
ELAPSED TIME AND REPEAT RECORDING TIMES DISPLAY
The repeat recording times and elapsed time are shown on the bottom of the Maintenance
menu.
ELAPSED TIME
The elapsed time indicates the total time the VCR has been used for recording and playback
(up to 89,999 hours). Use the elapsed time as a guide for periodic parts replacement.
REPEAT REC TIMES
• The repeat recording times displays the number of times a tape has been recorded
on. The number of tape uses increments by one when the tape ends during recording
(except when TAPE END in the First Time Set Up menu is set to STOP).
• The number of tape uses is kept even if AC power is disconnected, provided the
backup battery is fully charged.
• The number of tape uses is reset when a new tape is inserted.
• The number of tape uses shown can be up to 200. OVER appears if 200 times is
exceeded.
To view:
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select MAINTENANCE, and then turn the SHUTTLE ring right.
The Maintenance menu appears. The repeat recording times and elapsed time are
shown at the bottom of the screen.
3. Press the MENU button. The day and time display appears.
PLAYBACK
PLAYBACK PROCEDURE
002
<MAINTENANCE>
POWER LOSS LIST
ALARM LIST
ALL MENU INITIALIZE
POWER LOSS LIST CLEAR
ALARM LIST CLEAR
<REPEAT REC TIMES> 0
<ELAPSED TIME> 0H
00294
REMOTE
PICTURE
SOFT SHARP
REC/PLAY
MODE
TRACKING
JOG/ADJUST
EJECT REC
SHUTTLE
CLEAR/
REW
ENTER/
FW
MENU
/
TIME DATE ADJUST
PLAY/
REC CHECK
COUNTER
RESET
PAUSE/
SUTTLE HOLD
STOP
SEARCH TIMER REC
POSITON/
VERTICAL
ADJUST
3
4
2
1
Figure 21. Playback Controls
1. Load a pre-recorded tape. (Turn on the VCR and peripherals if you have not already
done so. If the erasure prevention tab has been removed, the VCR automatically
begins playback mode.)
2. Press the REC/PLAY MODE buttons (+) or (-) to select the desired playback mode.
(Refer to the
Playback Mode
section for more information.)