Filter
Top Products
26 Pelco Manual C671M (1/01)
TIMER PROGRAM
Figure 15. Timer Program Illustration
This is where you set the program number, day of the week, starting and ending times, and
the recording mode. (Refer to the
Timer Recording
section for more detailed information
and procedures.)
(program number) This number identifies the program (eight maximum). If the
recording times of two programs overlap, the higher program
number has priority.
DW Day of the week. DAY is used to record at the same time every
day. SPL (special) uses the start/end days selected with
SPECIAL DW at the bottom of the screen. HLD is used to control
recording on holidays (20 maximum).
START/END The VCR uses a 24-hour display for starting and ending recording
times. 00:00 indicates midnight; 12:00, noon; and 15:00, 3 p.m.
An indicator between the START and END columns shows that
recording continues to the following day.
HR This is the recording mode. SKIP indicates that timer recording is
not performed during the set period.
00261
<TIMER PROGRAM>
SPECIAL DW MON-FRI
PROGRAM NUMBER
DAY OF THE WEEK
RECORDING START TIME
RECORDING END TIME
NEXT DAY INDICATOR
RECORDING MODE DISPLAY