Filter
Top Products
Diagnostic Software, Trouble Shooting and Test Instructions
EN 33DVD963SA 5.
4 Basic Engine...
5 Processor Peripherals...
6 Error Log...
7 Furore...
8 Miscellaneous...
First Level Submenus
MAIN > AUDIO MENU
1 Mute...
2 Pink Noise...
3 Sine Wave...
4 Digital Ports...
5 Ext. DAC Board...
MAIN > VIDEO MENU
1 Colourbar...
2 Scart...
3 Digital Port...
MAIN > FRONT PANEL MENU
1 Slave Processor...
2 VFT Display [30a]
3 LCD Display [30b]
4 LCD BkLight [30c]
5 Keyboard [27]
6 LEDs [29]
7 Remote Control [28]
8 P50 Check [60]
MAIN > BASIC ENGINE MENU
1 Reset [44]
2 Version [37]
3 S2B...
4 Loader Mechanism...
5 Special Diagnostics...
MAIN > PROCESSOR PERIPHERALS MENU
1Clock...
2 Flash...
3 NVRAM...
4 SDRAM Write/Read [16]
MAIN > ERROR LOG MENU
1 Read Last Errors [31]
2 Read Error Bits [32]
3 Reset Error Log [33]
MAIN > FURORE MENU
1 SDRAM Write/Read [63]
2 SDRAM Write/Read [64]
3 Chip Revision ID [65]
4 Set DSD_PCM Output High [84a]
5 Set DSD_PCM Output Low [84b]
6 Reset Furore IC [83]
MAIN > MISCELLANEOUS MENU
1 Statistics Info...
2 Read DVD Application version[46]
Second Level Submenus
MAIN > AUDIO > MUTE MENU
1 Mute On [19a]
2 Mute Off [19b]
3 Mute Front LR On (963 only) [19c]
4 Mute Front LR Off (963 only) [19d]
MAIN > AUDIO > PINK NOISE MENU
1 Pink Noise On [20a]
2 Pink Noise / Beep Tone Off [20b]
3 Beep Tone On [20c]
MAIN > AUDIO > SINE WAVE MENU
1 Audio Sine On [21a]
2 Audio Burst On [21b]
MAIN > AUDIO > DIGITAL PORTS MENU
1 No tets available
MAIN > AUDIO > EXT DAC BOARD MENU
1. DAC Reset [79]
2. I2C Test...
3. Clock...
4. Audio...
5. Low Power Standby...
6. DAC Mode...
MAIN > VIDEO > COLOURBAR MENU
1 Colourbar DENC On (PAL) [23a]
2 Colourbar DENC On (NTSC) [23c]
3 Colourbar DENC/MPEG Off [23b]
4 ProgressiveScan MPEG On [24a]
5 Enhanced YUV MPEG On [24b]
6 Set Video Out To RGB [61a]
7 Set Video Out To YUV [61b]
MAIN > VIDEO > SCART MENU
1 I2C Scart IC Check [54]
2 Scart To DVD [55a]
3 Scart Pass Through [55b]
4 Scart Pin 8 Low (0 to 2)V [25a]
5 Scart Pin 8 Mid (4.5 to 7)V [25b]
6 Scart Pin 8 Hi(9.5 to 12)V [25c]
MAIN > VIDEO > DIGITAL PORT MENU
1 Video Port Out 0xAA [17a]
2 Video Port Out 0x55 [17b]
3 P-scan board IO exp [17c]
MAIN > FRONT PANEL > SLAVE PROCESSOR MENU
1 Bus Comms Check [12]
2 S/W Version [26]
MAIN > BASIC ENGINE > S2B MENU
1 S2B Echo [13]
2 S2B Pass-Through [14]
MAIN > BASIC ENGINE > MECHANISM MENU
1 Disc Motor...
2 Laser...
3 Tray...
4 Focus...
5 Radial...
6 Sledge...
7 Grooves...
MAIN > BASIC ENGINE > SPECIAL DIAGNOSTICS MENU
1 Read FlashID [70]
2 ROM Checksum [71]
3 Scratch Circuit [72]
MAIN > PROCESSOR PERIPHERALS > PCM CLOCK MENU
1 Ext PCM_CLK In CDDA Mode (11.3MHz) [7a]
2 Ext PCM_CLK In DVD Mode (12.3MHz) [7b]
3 Ext PCM_CLK In DVD96kHz Mode (24.6MHz) [7c]
MAIN > PROCESSOR PERIPHERALS > FLASH MENU
1 Verify FLASH Checksum [6]
2 Show FLASH Checksum [62]
MAIN > PROCESSOR PERIPHERALS > NVRAM MENU
1 I2C NVRAM Acces [11]
2 NVRAM Config [34]
3 NVRAM Reset [35]