Filter
Top Products
39
PIP
213
546
879
0
TV
SWAP PIP CH
DN
UP
FREEZE
SOUND
MUTE
SURF
A/CH
POWER
PICTURE
STATUS/
EXIT
POSITION
VCR
ACC
MENU/
SELECT
VOL
CH
TV/VCR
ACTIVE
CONTROL
3,4,
5
1
2
PICTURE
SOUND
FEATURES
INSTALL
TIMER
AutoLock
PIP
CLOSED CAP
FORMAT
TIMER
AutoLock
PIP
CLOSED CAP
FORMAT
TIME
START TIME
STOP TIME
CHANNEL
ACTIVATE
FEATURES
TIMER
FEATURES
TIME 8:06 PM
START TIME
STOP TIME
CHANNEL
ACTIVATE
8
TIMER
FEATURES
TIME
START TIME _ _:_ _
STOP TIME
CHANNEL
ACTIVATE
TIMER
FEATURES
TIME
START TIME
STOP TIME _ _:_ _
CHANNEL
ACTIVATE
TIMER
FEATURES
TIME
START TIME 8:00 AM
STOP TIME
CHANNEL
ACTIVATE
7
6
9
2
TIMER
FEATURES
TIME
START TIME
STOP TIME 9:30 AM
CHANNEL
ACTIVATE
SETTING THE TIMER’S START TIME AND STOP TIME
Y
ou can set the Timer to switch to a selected
channel at a specific time while you are
watching another channel, or when the TV is in
standby mode. (Standby mode is when the TV is
plugged into the wall outlet but turned off.) If
you want, you can also set the TV to turn off at
some time after the TV switches channels.
Follow the steps below to set the Timer’s
START TIME and STOP TIME.
1
Press the MENU/SELECT button
on the remote control to show the
onscreen menu.
2
Press the CURSOR RING DOWN
twice to highlight FEATURES.
3
Press the CURSOR RING RIGHT to
enter the FEATURES submenu.
4
Press the CURSOR RING RIGHT
again. Then press the CURSOR RING
DOWN once to highlight the START
TIME control.
5
Press the CURSOR RING RIGHT
to highlight the time indicator area.
6
Press the NUMBER buttons to enter
the correct time. If you make a mis-
take entering the time, use the
CURSOR RING LEFT or RIGHT to
move among the time input slots to
make corrections.
NOTE: You can also use the
CURSOR RING UP or DOWN to
cycle through digits to input the time.
7
Press the CURSOR RING UP or
DOWN to select AM or PM.
8
Press the CURSOR RING LEFT
repeatedly until START TIME is high-
lighted. Then press the CURSOR RING
DOWN to highlight STOP TIME. If you
want the TV to switch off at some time
after the changing of channels, follow
steps 5–7 above to set the STOP TIME.
9
Press the STATUS/EXIT button to exit
the menu.
See pages 40 and 41 for instructions on selecting
the Timer’s channel and activating the timer.
BEGIN
Using the Onscreen Submenus: Features