Filter
Top Products
43
Programming the Remote to Operate Peripheral Equipment
Watching Videos and DVDs
1
Connect the external equipment to the Display and Power Off the
external equipment.
2
Press both buttons simultaneously for more
than 3 seconds.
+
Release the buttons when the equipment selection
buttons start flashing.
3
Select the equipment.
VCR DBS/CBL
DVD
The selected button remains lit (other buttons are not lit).
4
Input the equipment’s 4-digit remote control
code.
(see page 47, 48)
5
Operate the equipment with the remote
control.
(see page 47)
The external equipment turns On.
Press to return to the Display mode.
DISPLAY
If the equipment does not operate with the remote control
When your equipment has a single code
Input the remote control code again
When your equipment has multiple codes
Change the code with 4 above and test again
Note:
Registration will fail if the wrong code is input or it takes more than 30 seconds to register.
•
•
To find a code not listed in the code list
This procedure searches all codes and is called the “sequence method.”
1 After step 3 above, change the code and test. 2 When the correct code is found.
change
store
Operate the equipment with the remote control.
(see page 47)
Repeat until the code is found.
It may take many attempts before the correct code is
found.
•
•
COMPO.
PC
INPUTCH
HDMI
フ
DISPLAY
HDMI
PC
DISPLAY
You can operate other manufacturers’ equipment using this Display’s remote control.