Pioneer DVD-V7200 DVD Player User Manual


 
45
<VRB1208>
BARCODE/COMAND STACK
Through external input of a synchronization signal (black burst), video output signals can be synchronized with external signals on
the DVD-V7200. (During DVD disc playback.)
Through the use of this function, video switch timing can be matched, and switching can be done without causing picture disturbance
on the TV without the need for such devices as a TBC (Time Base Collector).
INTERFACE CONNECTOR
AUDIO OUT
EXIT SYNC IN
BLACK BURST
COMPONENT VIDEO OUT
COMPOSITE VIDEO OUT
OFF ON
VIDEO 1
VIDEO 2
S2-VIDEO
COMPONENT
COMPOSITE
(MONO)
AUDIO
OUT
PCM/
DIGITAL OUT
R
YCb
Cr
L
AC IN
DC 5V 40mA
INTERFACE CONNECTOR
AUDIO OUT
EXIT SYNC IN
BLACK BURST
COMPONENT VIDEO OUT
COMPOSITE VIDEO OUT
OFF ON
VIDEO 1
VIDEO 2
S2-VIDEO
COMPONENT
COMPOSITE
(MONO)
AUDIO
OUT
PCM/
DIGITAL OUT
R
YCb
Cr
L
AC IN
DC 5V 40mA
INTERFACE CONNECTOR
AUDIO OUT
EXIT SYNC IN
BLACK BURST
COMPONENT VIDEO OUT
COMPOSITE VIDEO OUT
OFF ON
VIDEO 1
VIDEO 2
S2-VIDEO
COMPONENT
COMPOSITE
(MONO)
AUDIO
OUT
PCM/
DIGITAL OUT
R
YCb
Cr
L
AC IN
DC 5V 40mA
SIGNAL
GND
SIGNAL
GND
SIGNAL
GND
EXTERNAL SYNCHRONIZING FUNCTION
Sync accuracy ± 1H for input synchronization signal (During DVD disc playback)
NOTE:
Externally synchronizing 2 or more DVD-V7200 players, simultaneously starting video, and obtaining sync at the frame position for
playback is not possible with this player.
Because of timing of reception of the STILL to PLAY command and DVD disc content, an unevenness of approximately 2 frames
may occur.
Sync generator
Input: Black burst signal
Synchronized use of 2 or more players
÷ Make sure that the terminator switch is ON on the terminal
player and OFF on the other players.
÷ When applying synchronization to one player, set the terminator
switch to ON.
ON
OFF
OFF
No.1No.2No.....X
EXTERNAL SYNCHRONIZING FUNCTION