Recording
06
52
En
5 Press HOME MENU and select ‘Timer Recording’,
then ‘Auto Start Rec’.
6 Select ‘Start’ to switch Auto Start Recording on,
or ‘Cancel’ to switch off.
7 Switch the recorder into standby.
The
AUTO
indicator in the front panel display lights.
The recorder will automatically switch on and start
recording when the other component comes on.
Recording stops when the external component switches
off.
• To cancel Auto Start Recording, press
STANDBY/
ON
. The indicator goes off.
• To cancel Auto Start Recording once recording has
already started, press
ì
REC
for 3 seconds, then
STOP REC
.
• If you use the
ì
REC
button to extend a timer
recording that is active during Auto Start Recording
standby, Auto Start Recording is canceled. (If you
want to program a new end time for the timer
recording, press the front panel + button for 3
seconds, then program the new time (see also
Extending a timer recording in progress
on page 49).
Note that Auto Start Recording is canceled when you
do this.)
Note
• You can’t set Auto Start Recording when:
• the recorder is recording or in timer recording
standby.
• there is no recordable disc loaded.
• the disc loaded is locked.
• the disc loaded already contains the maximum
number of titles (99).
• If Auto Start Recording is set, it will not start if
another timer recording is in progress.
• Timer recordings take precedence over Auto Start
Recording. Auto Start Recording will stop if a timer
recording is due to start. After the timer recording
has finished, Auto Start Recording will resume.
Recording from a DV camcorder
(DVR-320 only)
You can record from a DV camcorder connected to the
DV IN/OUT
jack on the front panel of this recorder. Using
the recorder’s remote, you can control both the
camcorder and this recorder.
Before recording, make sure that the audio input for the
DV IN/OUT
jack is setup (see
DV Input (DVR-320 only)
on
page 78).
Important
• The source signal must be DVC-SD format
• Some camcorders cannot be controlled using this
recorder’s remote.
• If you connect a second recorder using a DV cable,
you cannot control the second unit from this one.
• You can’t control this unit remotely from a
component connected to the
DV IN/OUT
jack.
• You can’t record date and time information from DV
cassette.
• During DV recording, if a part of the tape is blank, or
has copy-protected material on it, this recorder will
pause recording. Recording will restart automatically
when there is a recordable signal.
• For best results when recording from a DV
camcorder to this recorder, we recommend cueing
the camcorder to the place you want to start
recording from and setting the camcorder to play-
pause.
VR mode Video mode
RETURN
HOME
MENU
ENTER
CLEAR
PAUSE STOP
REV SCAN PLAY FWD SCAN
STEP/SLOW
REC MODE
ì
DVR-04_KU.book 52 ページ ２００４年１月２８日 水曜日 午前１０時１５分
