Pioneer PDK-50HW3 Flat Panel Television User Manual


 
20
3. Installation Procedures
3.4 Adjusting the Plasma Display
3.4.1 Procedures for setting the plasma display
For details, refer to the Technical Manual of the plasma display.
1. First, set the System Settings.
Set SIGNAL FORMAT.
To use 1280 x 768 (60 Hz/70 Hz) screen resolution and refresh rate, set SIGNAL FORMAT to WXGA.
With the screen image turned on, select MENU = SETUP = SIGNAL FORMAT = SET, and change the
XGA setting to WXGA.
Example of menu displayed on the PDP-504CMX/PDP-50MXE1/PDP-50MXE1-S
:
SET
MENU
XGA
:
:
SIGNAL FORMAT
CLAMP POSITION
:
AUTO
POWER MANAGEMENT
OFF
MENU INPUT1
ENTER EXIT
PICTURE SCREEN SETUP OPTION
2. Next, adjust SCREEN to set the image position and clock.
Notes:
Confirm that MASK CONTROL and ORBITER are set to OFF. Consult the plasma displays Operating Instructions for details
on how to confirm these settings.
Confirm that the ENERGY SAVE item is set to STANDARD.
The proper screen settings cannot be made if POINT ZOOM is used to enlarge part of the screen, or if SPLIT button is used to
divide the screen into multiple smaller screens.
If AUTO SET UP MODE is set to ACTIVE, the displayed screen may require recalibration.