Filter
Top Products
UN IVERSAL REMOTE FEATURES
The CRK76TKI remote can be programmed to control most brands of
remote controllable components. The remote is already programmed to
control most RCA, GE and PROSCAN components; it may need to be
programmed to control other manufacturers' components.
Testing the Universal Remote
To determine whether the universal remote control needs to be
programmed, turn a component on, such as a VCR, point the remote at
the VCR, and press the VCR button. Then press ON*OFF or CH ^Iv to see
if the VCR responds to the remote commands. If not, the remote needs
to be programmed.
Programming the Universal Remote
I. Turn on the component to be programmed.
2. At the end of this section, look up the code list that corresponds to
the component type and brand.
3. On your remote control, press and hold the component button you
want to program.
4. Enter one four-digit code from the code list.
5. Release the component button, and then press ON.OFF to see if the
component responds to the remote control commands. If it doesn't,
try pressing the component button and then ON.OFF again.
6. If you get no response, repeat these steps using the next code listed
for your brand, until the component responds to the remote
control. If it does respond, you are ready to control that component
with your universal remote.
CONTROLLI NG COMPONENTS
Once the remote has been programmed successfully, you are ready to
use it to control your components. To operate the component:
I. Press the component button (TV, VCRI, DVD, VCR2, AUX, or
SAT.CABLE) to put the remote into that component's mode.
2. Press ON.OFF to turn the component on or off.
3. Use the remote control buttons that apply to that component.
• If your remote is programmed to control a VCR, you only need to
press the RECORD button to begin recording from video.
Modes of Operation
Because this universal remote can control several different components
(PC, VCR, cable box, etc.), it uses operational modes triggered by the
component buttons. If you want the remote to control the TV, you must
press the TV button to put the remote into TV mode first.
I his remote control may not operate all |
models of all brands.
J
(
The RESETbutton on this remote |
J
functions the same as the Master remote
RESET or Basic remote SKIP button,
13