Filter
Top Products
TROUBLESHOOTING
Can't select certain channel
• Channel may be blocked or not approved in the
Parental Controls or Access and Power Options menu.
• Channels not in the current channel list cannot be
accessed except through the master Channel menu.
• If using a VCR, check to make sure the TV/VCR button
on the VCR is in the correct "mode."
Input signal problems
• Make sure that the input channel choice in the Auto
Tuning menu matches the component's physical
connection. For example, if you have set VCR1 to CH4
in AutoTuning, but the VCR is connected by Audio/
Video cables or an S-Video cable, you will see normal
channel 4 programming when the VCR1 button is
pressed. See the Auto Tuning description under
Channel Menu in the "Master Menus" section for
further instruction.
Rating limits don't work
• You must lock the parental controls (from the Main
menu, select Parental Controls, then Lock Parental
Controls).
Menu problems
• The Basic Menu Access function may be disabled in the
Access and Controls menu.
• Menu access may be blocked by clone box
programming.
• Try unplugging the TV for two minutes and then plug
it back in and turn it on.
• The Energy Saver settings will not work if TV Power is
set to Always in the Access and Power Options menu.
• The basic menu options might be restricted by master
menu settings.
Program is blocked and it shouldn't be
• It may be a Not Rated (NR) movie. After you block
movie ratings, you must set NR to View separately in
order to view movies with an NR rating (from the Main
menu, select Parental Controls, then V-Chip Movie
Rating Limit).
• It may be an unrated television program. To unblock
unrated television programs, select Parental Controls
from the Main menu, then select V-Chip TVRating
Limit and set unratedto V.
I CAUTION: If fixed (non-moving) images are left on the screen for long periods, they may be permanently imprinted on the |
picture tube. Such images include network Iogos, phone numbers, and video games. This damage is not covered by your
J
warranty. Extended viewing of channels displaying these images should be avoided.
Care and Cleaning
CAUTION: Turn OFF your TV before cleaning.
You can clean the TV as required, using a soft lint-free cloth. Be sure to occasionally dust the ventilation slots in the cabinet
to help assure adequate ventilation.
The TV's screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the screen. If necessary,
you may use a cloth dampened with warm water.
Never use strong cleaning agents, such as ammonia-based cleaners, or abrasive powder. These types of cleaners will
damage the TV.
While cleaning do not spray liquid directly on the screen, or allow liquid to run down the screen and inside the TV. Also,
avoid placing drinks or vases with water on top of the TV. This could increase the risk of fire or shock hazard or damage to
_, the TV.
43