Filter
Top Products
Connections & Setup
20 Chapter 1
Step 3: Configuring for Cable
The next series of screens asks you about your cable setup. To supply
your TV with the correct TV program listings, the GUIDE Plus+ system
needs to know if your TV is connected to cable.
1. If your TV is connected to cable, highlight Yes and press OK.
If your TV isn’t connected to cable, highlight No and press OK.
2. If you have a cable box connected to this TV, highlight Yes and press
OK on your remote control.
Note: The next series of screens is very important because the
GUIDE Plus+ system must find the correct cable box information in
order to receive the correct TV program listings.
If you don’t have a cable box connected to this TV, highlight No and
press OK. Then go to page 22.
3. Use the arrow buttons to highlight your brand of cable box, and
press OK.
If your brand isn’t listed, highlight Not Listed and press OK.
4. Make sure your cable box is on.
5. Tune the cable box to channel 02 (use the remote control that came
with your cable box, or press the channel buttons on the cable box).
Press OK (the GUIDE Plus+ system starts testing codes).
Important: When code testing is in progress, don’t touch your TV,
VCR, cable box, or any of the remote controls for these products.