Filter
Top Products
Graphics contained within this publication are for representation only.
37
Chapter 3: Recording, Playback & Features
VCR Basics
The VCR part of your DVD/VCR has all the basic functions of other VCRs. The basic concepts are
explained below and the advanced VCR features are explained on page 38.
Basic Playback
1. Tune the TV to your DVD/VCR viewing channel (03, 04, or the Video Input Channel).
2. Insert a tape in the DVD/VCR.
3. Press PLAY to play the tape.
Note: If both a DVD disc and VCR tape are in the DVD/VCR, the DVD disc plays automatically
when you press PLAY. To play a tape, go to the main menu (press MENU), select
Tape
, and press
PLAY to start playing the tape.
• Press FORWARD or REVERSE to cue the tape to the desired position during Play mode.
• To advance the tape approximately 30 seconds at a time during Play mode, press the ADVANCE
button on the remote control.
• To go back approximately 10 seconds during play mode, press the AGAIN button.
• Press PAUSE to stop action. For slow-motion playback, press FORWARD (while picture is paused).
To move one frame at a time, press PAUSE on the remote (while paused)—each time you press
PAUSE, the video moves forward one frame.
• Press the CH +/CH- buttons to remove any streaks from the picture, if necessary.
• Press STOP to stop playback.
Tape Eject
Press the STOP/EJECT button on the DVD/VCR when stopped to eject the tape. You can also press
the OPEN•CLOSE button on the remote control to eject the tape.
Basic Recording
1. If necessary, change the tape speed (SP or SLP) in Recording Options menu (page 57).
2. If you’re watching TV, press the RECORD button on the front of the DVD/VCR (the VCR’s
RECORD button that is next to the STANDBY/ON button turns on) to begin recording.
3. Press the STOP button to halt recording.
If you just want to pause the recording for a short time (like during a commercial), press PAUSE
instead of STOP. To resume recording, press the RECORD button on the remote control.
Check the Safety Tab
Make sure there is a tape in the DVD/VCR with its safety tab in place. You cannot record on a tape if
the safety tab has been removed. If the safety tab is removed and you want to record, simply cover the
hole with adhesive tape.
GO
BACK
VOL CH
MUTE
TV
ON-OFF
DVD/VCR CABLE
AUX
AUDIO
CLEAR
MENU
OK
LIVE
RECORD
STOP
PLAY
INPUT ANTENNA
PAUSE
FORWARDREVERSE
7
123
4
5
6
8
0
9
ADVANCE
AGAIN
INFOTIMER•GUIDE
SAT
ZOOM EDIT
OPEN
CLOSE
ANGLE
Safety Tab