Filter
Top Products
Connections and Setup
12 Chapter 1
Graphics contained within this publication are for representation only.
Plug in the Monitor
Plug the flat end of the cable into the power jack on the back of the
monitor. Then plug the end of the power cord into an appropriate
wall outlet. Be sure to insert the plug completely. Do not plug into an
outlet controlled by a light switch.
Put batteries in the remote
• Remove the battery compartment cover from the back of the
remote by pushing down on and sliding off the cover.
• Insert 2 fresh “AA” batteries. Make sure the polarities (+ and -) are
aligned correctly.
• Replace the cover.
Turn on the Monitor
1. Push in the main power button on the back of the monitor
(located on the lower-left side).
2. Press MONITOR on the remote, or press POWER on the monitor’s
front panel.
Note: Pressing the MONITOR button turns on the monitor and
puts the remote into monitor mode. “Monitor mode” means
that the buttons on the remote control operate the monitor’s
functions.
Set up Your Monitor
The first thing you need to do after turning on your plasma monitor is
to tune it to the Video Input Channel which corresponds to how it is
connected to the video source signal from the HD receiver, satellite
receiver, or cable box. Make sure the remote is in the monitor mode
by pressing the MONITOR button, then press the INPUT button
repeatedly until the signal appears for the input you have connected.
Remember, the monitor is dependent on an external source for
programming (HD receiver, cable box, etc); it can’t receive channels
on its own.
Choose the Menu Language
If want to change the language of the on-screen displays, follow the
steps below. The default language is English.
1. Press the MENU button on the remote control (the MAIN MENU
appears).
2. Press the down arrow button to highlight Preferences, then press
OK (the Preferences menu appears with Language highlighted).
3. The default language is English. To select French or Spanish, press
the right arrow button.
The back of the monitor
Main power button