Filter
Top Products
Connections and Setup
8 Chapter 1
Graphics contained within this publication are for representation only.
Choose Your Connection
There are several ways to connect your plasma monitor, depending on the components you
want to connect and the quality of the signal you want to achieve. The following are general
connection examples. Choose the connection which is best for you.
Note: If you prefer, we can provide you with the name of an Authorized Service
Representative who will visit your home for a fee to install your electronic entertainment
system and to instruct you in its operation. For details about this service, call 1-888-206-
3359. For additional assistance while using your RCA product, please visit www.rca.com/
customersupport.
Connection to audio/video components
Using the VID1 and VID2 jacks
Connect a component, such as a VCR, DVD player or satellite receiver, to the monitor using the
VID1 or VID2 jacks. Connect an S-Video cable to the S-VIDEO In jack and to the S-Video Out
jack on the component. Then connect audio cables to the Audio In L and R jacks on the back
of the monitor and to the Audio Output jacks on the component.
Notes:
• If S-Video and composite video are connected at the same time, S-Video takes priority.
• If the component you are connecting only has a video jack, connect the component to
the monitor’s VID1 VIDEO jack using a standard video cable.
AV component
VID 1
VIDEO
R
L
S-VIDEO
AUDIO