Filter
Top Products
Connections and Setup
4 Chapter 1
Graphics contained within this publication are for representation only.
Installation of the Monitor
Installation using a stand or wall mount bracket
• Please be sure to request installation or mounting of this unit or the installation bracket by the dealer where
purchased.
•When installing, be sure to use the bolts provided with the stand or installation bracket.
• For details concerning installation, please refer to the instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the stand or installation bracket (sold separately)
•When possible, please install using parts and accessories manufactured by Thomson. Thomson will not be held
responsible for accident or damage caused by the use of parts and accessories manufactured by other companies.
• For custom installation, please consult the dealer where the unit was purchased.
Note for U.S. customers: If you prefer, we can provide you with the name of an Authorized Service
Representative who will visit your home for a fee to install your electronic entertainment system and to instruct you
in its operation. For details about this service, call 1-888-206-3359.
For additional assistance while using your RCA product, please visit www.rca.com/customersupport.
CAUTIONS
To avoid malfunction, overheating of this unit, and possible fire hazard, make sure that the vents on the main unit
are not blocked when installing. Also, as hot air is expelled from the air vents, be careful of dust build up on rear
surface wall, etc.
This monitor unit is very heavy and has little front-to-back depth, making it very unstable when stood on edge. The
monitor should either be attached to the table stand or mounted on the wall. No other mounting method is
recommended. As a result, two or more persons should cooperate when unpacking, moving, or installing the
monitor.
This unit incorporates a thin design. To ensure safety if vibrated or shaken, please be sure to take measures to
prevent the unit from tipping over.
Mounting or Removing the
Table Stand
To mount the monitor to the stand:
1. Lift the plasma monitor and insert the 4
mounting posts on the back of the unit
into the mounting holes on the table
stand.
2. Make sure all the posts are fully inserted,
then let the monitor slide down into the
smaller notches until the posts fit firmly
into place.
3. Insert the screws into the holes on the
back of the stand (as shown) and tighten
them into place.
To remove the monitor from the stand:
Remove the screws, and follow the above
steps in reverse order.
Stand holes for
the monitor’s
mounting posts