Filter
Top Products
Chapter 1 17
Connections and Setup
Using Direct Entry
1. Turn on the component you want the remote to operate (the red light on the remote turns
on).
2. Look up the brand and code number(s) for the component on the code list on the following
pages.
3. Press and hold the component button that corresponds to the component you want the remote
to operate (VCR, RCA DVD, etc.).
4. Enter the code from the code list. When you begin entering numbers, the red light on the
remote turns off. When the last number is entered, the red light turns back on. If the incorrect
code is entered, the red light will flash.
5. Release the component button. The red light on the remote turns off.
6. Press ON•OFF to see if the component responds to the remote commands. If it doesn’t, try
pressing the component button and then ON•OFF again.
6. If you get no response, repeat these steps using the next code listed for your brand, until the
component responds to the remote commands.
How To Use the Remote Control After You’ve Programmed It
Once the remote control has been programmed successfully, you’re ready to use it to operate
other components.
1. Press one of the video source buttons to select a component (VIDEO or RGB) to operate.
2. Press the component button (MONITOR, VCR, DVD, AUX, or HD RCVR) to use the Transport
buttons (REVERSE, PLAY, FORWARD, STOP, PAUSE, and RECORD) to operate the component.
3. Press ON•OFF to turn the component on or off.
NOTE: If you keep pressing buttons and nothing happens, you may have the wrong video
source or wrong component selected. You must select the correct video source and the
component button that matches the component you want to operate.