Filter
Top Products
Safety Information
WARNING
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol indicates “dangerous
voltage” inside the product that
presents a risk of electric shock
or personal injury.
This symbol indicates
important instructions
accompanying the product.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Precautions
Please read this manual carefully before using your Monitor and
keep the manual handy for future reference.
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO DO
NOT USE THIS UNIT’S PLUG WITH AN EXTENSION
CORD RECEPTACLE OR OTHER OUTLETS, UNLESS ALL
PRONGS CAN BE FULLY INSERTED. REFRAIN FROM
OPENING THE CABINET AS THERE ARE HIGH-VOLTAGE
COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
Industry Canada Compliance Notice
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
Declaration of Conformity
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Product: Cinema Screen Display
Equipment Classification: Class B Computer Peripheral
Model: PHD50300
We hereby declare that the equipment specified above conforms to
the technical standards as specified in the FCC rules.
Thomson multimedia Inc.
10330 N. Meridian St.
Indianapolis, IN 46290
Phone: 1-800-433-8974
Cable TV Installer: This reminder is provided to call your
attention to Article 820-40 of the National Electrical Code (Section
54 of the Canadian Electrical Code, Part 1) which provides
guidelines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding system of
the building as close to the point of cable entry as practical.
FCC Information
• FCC Regulations state that unauthorized changes or
modifications to this equipment may void the user's authority
to operate it.
• This equipment has been type tested and found to comply
with the limits for a Class B Digital Device in accordance
with the specifications in Part 15 of the FCC rules. These
rules are designed to provide reasonable protection against
radio and television interference in a residential installation.
This equipment generates and can radiate radio frequency
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause interference to the radio or
television reception (which you can determine by turning the
equipment off and on), try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna (that is,
the antenna for the radio or television that is
"receiving" the interference).
• Change the position of the monitor with respect to
the radio or television equipment that is receiving
the interference.
• Move the monitor away from the equipment
receiving the interference.
• Plug the monitor into a different wall outlet so the
receiver and the equipment are on different branch
circuits.
If these measures do not eliminate interference, please
consult your dealer or an experienced radio/television
technician for additional suggestions. Also, the Federal
Communications Commission has prepared a helpful
booklet, "How to Identify and Resolve Radio/TV Interference
Problems." This booklet is available from the U.S.
Government Printing Office, Washington D.C., 20402. Please
specify stock number 004-000-00345-4 when ordering copies.