Filter
Top Products
11
SETUP
The setup procedure
will help you configure
your VCR. Would you
like to begin the
setup procedure now?
1 Begin setup
2 Cancel
Setting Up the VCR
Turn On the VCR
1. Press VCR1 on the remote.
The first time you turn on the VCR, the SETUP menu will appear. Follow the
steps on the screen to automatically set-up a satellite receiver or cable box,
set the time, auto channel search, and select some feature options.
■ Press number button 1 on the remote to Begin setup. Proceed to Auto
satellite receiver and/or cable box Setup.
■ Press number button 2 on the remote to Cancel the setup.
If you choose not to use the SETUP menu, follow the steps below to
manually set up the VCR so it will operate properly.
If the SETUP menu does not appear, or you prefer, you can manually select
the SETUP menu. Each of these features may also be performed individually.
To manually select the SETUP menu.
■ Press MENU¥PROG to display the VCR MAIN MENU.
■ Press 5 to display the SETUP menu.
Set Up a Digital Satellite Receiver and/or Cable Box
The DSS and cable box setups allow the VCR to record programs from a compatible
cable box and/or satellite receiver.
■ The VCR will turn on a digital satellite receiver and tune it to the channel you
want to record during timer recordings. Position the receiver above the VCR
to receive the infrared remote signal. (See pages 6-7.)
■ If your cable box can be controlled by remote, the VCR may be able to tune it
to the channel you want to record during VCR Plus+ and timer recordings.
Position the remote-controllable cable box on top of the VCR to receive the
infrared remote signal. (See pages 4-5.)
Set Up a Digital Satellite Receiver
1. Satellite receiver not used:
Press 2. Setup is not required.
Satellite receiver used:
Press 1 to continue.
2. Press two numbers on the remote to enter the channel that your VCR
receives signals from the receiver. Press 0 before a single-digit number.
Valid numbers are 02 Ð 69. Channels 3 and 4 are typical selections; however,
some satellite receiver models permit you to use a vacant UHF channel.
Refer to your receiver ownerÕs manual for details.
If you connected your receiver to the VCR using the receiverÕs
AUDIO/VIDEO OUT jacks, press INPUT to select VIDEO1 or VIDEO2.
Press CLEAR on the remote to correct an entry.
3. Press MENU¥PROG to proceed.
ÒThe VCR will now receive all signals from the DSS receiver onÓÐ Ð message
appears.
SETUP
Would you like to set
up the VCR to control
a DSS receiver?
1 Yes
2 No
DSS SETUP
On what ANTENNA channel
does the VCR receive
signals from the DSS
receiver?
--
Press 02-69 or INPUT
Press MENU to exit