Filter
Top Products
12
Startup
Set Up a Digital Satellite Receiver (continued)
4. Press MENU¥PROG to proceed.
Digital satellite receiver turned on:
The receiver turned on and tuned to channel 200. Press 1 and proceed to
CABLE BOX SETUP.
The VCR will now turn on and tune your receiver to the correct channel during
timer recordings. Ð Ð Ð DSS will appear for channels 100 and over in the timer
program menu.
Digital satellite receiver did not turn on:
If your receiver does not turn on, try repositioning the receiver and press 2 to
try again.
Cancel digital satellite receiver setup:
Press 3 to cancel DSS SETUP. The VCR will not turn on or control the receiver.
Set Up a Cable Box
5. Set up the VCR to control a cable box:
Press 1 if you would like to set up the VCR to control a cable box.
Press 2 if you do not want to set up the VCR to control a cable box.
6. Cable box not used for all channels:
Press 2. Setup is not required. Skip to Set Time and Date.
Cable box used for all channels:
Press 1 to continue.
Press two numbers on the remote to enter the channel that your VCR receives
signals from your cable box. Press 0 before a single-digit number. Valid
numbers are 01 Ð 13.
If you connected your cable box to the VCR using the boxÕs AUDIO/VIDEO
OUT jacks, press INPUT to select VIDEO1 or VIDEO2.
Press CLEAR on the remote to correct an entry.
7. Press MENU¥PROG to proceed.
The VCR will now receive all signals from the cable box on channel Ð Ð message
appears.
8. Press MENU¥PROG to proceed.
9. Manually Controlled Cable Box:
You are finished with cable box setup. Repeatedly press MENU¥PROG to exit
CABLE BOX SETUP. Proceed to Set the Time and Date.
Remote Controlled Cable Box:
Enter your cable box code from the chart on the next page and follow the on-
screen directions. The VCR changes the cable box from channel 02 to channel 09
when you enter the correct code for your cable box.
If none of the codes work, try repositioning the cable box and entering the codes
again. If the codes still do not work, this VCR cannot control your cable box
during VCR plus+ or timer recordings. Press MENU¥PROG to exit the CABLE
BOX SETUP. Proceed to Set the Time and Date.
Did the DSS receiver
turn on and tune to
channel 200?
1 YES, setup complete
2 NO, try again
3 NO, cancel setup
DSS SETUP
The VCR will now
receive all signals
from the DSS receiver
on ANTENNA channel 03
(or CABLE CHANNEL 03).
Press MENU to proceed
SETUP
Would you like to set
up the VCR to control
a cable box?
1 Yes
CABLE BOX SETUP
Do you use your cable
box to receive ALL
channels?
1 Yes
2 No
CABLE BOX SETUP
On what channel does
the VCR receive signals
from the cable box
(usually 3, 4, or video)
--
CABLE BOX SETUP
The VCR will now
receive all signals
from the cable box
on channel 03
CABLE BOX SETUP
Enter the code for your
cable box from the
list in your User's
Manual.
--
CABLE BOX SETUP
Please turn on the
cable box and tune
it to channel 2.
CABLE BOX SETUP
Did the cable box
tune to channel 9?
1 YES, setup is complete
2 NO, try again