Filter
Top Products
English - 43
System Setup
DTS
1. Off : Doesn’t output DTS signal. Select this
when your AV receiver or AV amplifier
does not have DTS decoder.
2. On : Outputs DTS Bitstream via digital output
when you play DTS track. Select this only
when your AV receiver (or AV amplifier)
have DTS decoder.
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
1. Off : You can enjoy the movie with the
standard Dynamic Range.
2. On : When Movie soundtracks are played at
low volume or from smaller speakers, the
system can apply appropriate
compression to make low-level content
more intelligible and prevent dramatic
passages from getting too loud.
Digital Output
1. PCM : Select this when your equipment is not
Dolby Digital compatible.
2. Bitstream : Outputs Dolby Digital (or MPEG-2)
audio as bitstream. Select this
when your AV receiver or AV
amplifier has a Dolby Digital (or
MPEG-2) Decoder.
■
Be sure to select the correct Digital
Output or you will hear no sound or a
loud noise.
NOTE
■
When DTS soundtrack is played, sound
does not output from AV Audio Output.
NOTE
03-DVD-HR720_XAA_30~48 2005.9.8 3:26 PM Page 43