Filter
Top Products
ENG-9
Setting the Date and Time
Your DVD-VCR contains a 24-hour clock and calendar
used to:
◆
Automatically stop programme recording
◆
Preset your DVD-VCR to record a programme
automatically
You must set the date and time when:
◆
You purchase the DVD-VCR
☛
◆
The time and date are set automatically
from the broadcast signal. If the signal is
weak or ghosting occurs, the time and
date may not be set automatically.
In this case, they should be set manually.
◆
Do not forget to reset the time when you
change clocks from winter to summer
time and vice versa.
1 After pressing the MENU, press the OK or
❿
.
Result: The Setup menu is displayed.
2 Press the corresponding
,
❷
buttons to select
the Clock option.
3 Press the OK or
❿
to select this option.
Result: The Clock Set menu is displayed.
4 Press
➛
or
❿
to select the hour, minutes, day,
month and year.
Result: The option selected highlight.
5 Press the
or
❷
buttons to increase or decrease
the value.
Result: The day of the week is displayed
automatically.
➢
You can hold the
or
❷
buttons down to scroll
more quickly through the values.
6 On completion, press RETURN to exit the menu.
Time Date Year
Clock Set
12 : 00 1 / JAN / 2004 THU
Tuning Your Television for the
DVD-VCR
It is only necessary to tune your DVD-VCR if you are
not using a SCART.
➢
To view pictures from your DVD-VCR when a
Scart cable is used, the television must be set to
the audio/video mode (AV).
1 Switch on the television.
2 Switch on the DVD-VCR by pressing STANDBY/ON
on the front of the DVD-VCR or STANDBY/ON on
the remote control.
3 Select a programme position on the television to be
reserved for use with your DVD-VCR.
4 Insert the video cassette in the DVD-VCR. Check
that the DVD-VCR starts reading the cassette;
if not, press
❿
II
button.
5 Start a scan on your television or set the television
to UHF channel 36.
6 Fine tune the television until the pictures and sound
are obtained clearly.
7 If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the DVD-VCR
output channel (see Setting the DVD-VCR Output
Channel on page 14 and Problems and Solutions
on page 45).
8 When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
with your DVD-VCR.