Filter
Top Products
ENG-8
Plug & Auto Set up
Your DVD-VCR will automatically set itself up when it
is plugged into the mains for the first time. TV stations
will be stored in memory. The process takes a few
minutes. Your DVD-VCR will then be ready for use.
1 Connect the coaxial cable as indicated on page 6
(Connecting Your DVD-VCR to the TV Using the
Coaxial Cable)
2 Plug the DVD-VCR into the mains.
Result : The Language Set menu is displayed.
3 Select the required language by pressing the
or
❷
buttons.
4 Press OK to store the language selected.
Result: A message appears.
5 Press OK button.
6 Press OK to start the auto scanning.
◆
The number of stations automatically stored by
the VCR depends on the number of stations
that it has found.
7 The current time and date are displayed
automatically.
Check the date and time.
if it is :
◆
Correct, Press RETURN button twice to exit the
menu.
◆
Incorrect, see page 9.
➢
Auto preset can be performed by pressing
■
on
the VCR continuously for 5 seconds or more
with no tape inserted.
1 AV2 IN: By means of 21-pin Scart Cable
Plug the SCART Cable with satellite receiver or
other equipment into the AV2 (DEC./EXT.) socket
on the rear of the DVD-VCR.
After making this connection, select the source by
pressing the INPUT SEL. button for the AV2 input
sources.
2 By means of RF Coaxial Cable
After making this connection, you must preset the
station received through the satellite tuner.
RF output channel of the satellite receiver should
be adjusted away from channel 36, which is used
by the DVD-VCR, e.g. re-adjust to channel 39.
Auto setup
Please wait
00 %
Clock Set
Time Date Year
12 : 00 1 / JAN / 2004 THU
SCART Cable
RF coaxial cable
Aerial
1
2
Satellite Receiver or other Equipment
Aerial Connector
TV
Connecting DVD-VCR to a Satellite
Receiver or Other Equipment