Filter
Top Products
ENG-17
Protecting a Recorded Cassette
Video cassettes have a safety tab to prevent accidental
erasure. When this tab has been removed, you cannot
record on the tape.
1 If you wish to protect a cassette, break off the tab
using a small screwdriver.
2 To re-record over a protected cassette (safety tab
broken), cover the hole with adhesive tape.
You can record a cassette at two different speeds:
◆
SP (Standard Play)
◆
LP (Long Play)
In Long Play modes:
◆
Each cassette lasts twice as long
◆
The recording is of a slightly lower
quality.
To record a cassette... Press the SPEED button on
the remote control, until...
In standard play mode SP is displayed.
In long play mode LP is displayed.
Selecting the Recording Speed
T
ype Recording Time (in SP)
E-180 180 mins. or 3 hours
E-240 240 mins. or 4 hours
E-260 260 mins. or 4 hours and 20 mins.
E-300 300 mins. or 5 hours
Selecting the Cassette Type
Repeat Play
If you wish to use the tape counter to display the time
remaining on a cassette, you must indicate the type of
cassette inserted.
1 After pressing the MENU press the corresponding
,
❷
buttons to select the VCR option.
2 Press the OK or
❿
buttons to select this option.
Result: The VCR Setup menu is displayed.
3 Press the corresponding
or
❷
buttons, until the
Tape Select option is selected.
4 Press the OK or
❿
buttons as many times as
required, until the correct cassette length is
displayed.
E180
E240
E 300
E260
5 Press RETURN twice to exit the menu.
Repeat Play : Off
VCR Setup
Tape Select : E180
E180
E240
E260
E300
VCR Setup
Tape Select : E180
Repeat Play : Off
Off
On
You can set repeat play to repeat the tape continuously
from beginning to end.
To... Press OK or
❿
, until...
Repeat play On is displayed.
Do not wish to repeat play Off is displayed.