Filter
Top Products
ENG-12
8 Press the
➛
or
❿
buttons to start scanning the
channels.
Result: The frequency band is scanned and the first
station found is displayed.
9 Press the
❷
button, until the DECODER is selected.
10 Press the
❿
button to activate or deactivate use of the
decoder for the TV station, if necessary.
11 Press the
or
❷
buttons until the NAME is selected.
The station name is set automatically from the
broadcast signal.
12 To change the programme’s name, press the
❿
button.
Result: The first letter of the name flashes.
13 To... Then...
Select a character Press the
or
❷
button until
the in the namerequired
character is displayed (letters,
numbers or “-” character).
Move to the next or
Press the
➛
or
❿
buttons
previous character
respectively.
14 If you... Then...
Wish to store the
◆
Press the
or
❷
buttons
station displayed until the MFT is selected.
◆
Press the
➛
or
❿
buttons to
adjust the picture, if necessary.
◆
Press OK to store the station
Do not wish to
◆
Press the
or
❷
buttons
store the station until the CH is selected.
displayed
◆
Press the
➛
or
❿
buttons to
go on scanning the
frequency band and display
the next station
◆
Go back to the beginning of
Step 14
15 Repeat this procedure from Step 6 onwards, until
all the required stations have been stored.
16 On completion, press the RETURN button three
times to exit the menu.
Clearing a Preset Station
☛
If you have stored a TV station:
◆
That you do not require
◆
At the wrong programme position you can
cancel it.
1 After pressing the MENU, press the OK or
❿
.
Result: The Setup menu is displayed.
2 Press the corresponding
,
❷
buttons to select
the Install option.
3 Press the OK or
❿
to select this option.
Result: The Install menu is displayed.
Auto Setup
Manual Setup
Install
TV System : K
VCR Output CH : CH 36
4 Press the corresponding
or
❷
buttons, until the
Manual Setup option is selected.
5 Press the OK or
❿
to select a Manual Setup option.
Result: The TV STATION TABLE menu is displayed.
6 Press the corresponding
or
❷
buttons, until the
required preset TV station (PR) is selected.
7 Press the CLEAR button.
8 Repeat the same procedure from Step 6 onwards
until all the required stations have been cleared.
9 On completion, press the RETURN button four
times to exit the menu.
PR CH NAME DEC
1 21
OFF
2
3
4
5
- - - -
TV STATION TABLE
SWAPPING : OK
DELETE : CLEAR RETURN
Presetting the Stations Manually