Filter
Top Products
ENG-27
Recoding from Another VCR
or Camcorder
Using the TV Buttons on the
Remote Control
You can copy a cassette to your DVD-VCR from
another video source, such as another VCR or a
camcorder.
☛
It is an infringement of copyright laws to copy
prerecorded cassettes or to re-record them in any
form without the permission of the owners of the
corresponding copyright.
1 Connect the DVD-VCR, from which the cassette is
to be copied, to the appropriate SCART audio and
video input connectors on the rear of your
DVD-VCR, as indicated on page 8.
2 Insert a blank cassette in your DVD-VCR.
3 Insert the pre-recorded cassette in the other video
source (VCR or camcorder).
4 Press the INPUT SEL. button to select the
appropriate input on your DVD-VCR:
◆
AV1, AV2 for the SCART input
◆
AUX for the RCA input
5 Start playing back the cassette to be copied.
6 Hold REC
(
●
)
down for a while to start recording
on your DVD-VCR.
7 When you have finished recording, press
■
on
both VCR and DVD-VCR.
➢
If you wish to view the cassette being copied:
◆
Your DVD-VCR must be connected as usual to
the television (see page 6 for further details).
Your DVD-VCR remote control will work with Samsung
televisions and compatible brands.
To determine whether your television is compatible,
follow the instructions below.
1 Switch your television on.
2 Point the remote control towards the television.
3 Hold down the TV button and enter the two-figure
code corresponding to the brand of your television,
by pressing the appropriate numeric buttons.
Brand Codes Brand Codes
SAMSUNG 01 to 06 PHILIPS 02, 20, 22
AKAI 09, 23 SABA 13, 14, 22 to 24
GRUNDIG 09, 17, 21 SONY 15, 16
LOEWE 02
THOMSON
13, 14, 24
PANASONIC
08, 23 to 27 TOSHIBA 07, 16 to 19, 21
Result: If your television is compatible with the
remote control, it will switch off. It is now
programmed to operate with the remote
control.
‚
➢
If several codes are indicated for your
television brand, try each one in turn until you
find one that works.
☛
When you change the batteries in the remote
control, you must reprogramme the code, following
the same procedure.
You can then control the television using the following
buttons.
Button Function
STANDBY/ON Used to switch the television and
DVD-VCR on and off.
TV or VCR Used to switch between the TV and
VCR modes.
INPUT SEL. Used to select an external source.
VOL + or – Used to adjust the volume of the
television.
PROG/TRK Used to select the required
( or ) programme.
TV MUTE Used to mute the volume of the
television.
➢
The various functions will not necessarily work
on all televisions. If you encounter problems,
operate the television directly.